\n
![\"billy01\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy01-800x600.jpg\")
<\/a><\/p>\n\n\n\nThe metal square holder was removed, and replaced with a 2 mm thick steel cable. Also I added to the lid a stainless steel D ring to make the removal or adding of the lid easier. Hanging. The steel cable holds in place with the help of a speaker connector. First I drilled 2 holes of 3.5 mm, since the D ring is 3 mm. The standard pan inside is still a part of the set, but not sure if I want to keep it. So far I never used it, other then holding the contents in place. Contents are a fire steel, a shortened pot holder (it was 1 cm too long to fit inside, so I cut it of), small box with tinder materials, a steel sponge, and a bag with salt, pepper, tea, and water purification tablets. Further I added a 0.5 L stainless steel cup with folding handles, and a cut of spork.
\n![\"billy02\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy02-800x600.jpg\")
<\/a><\/p>\n\n\n\n
\n![\"billy03\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy03-800x600.jpg\")
<\/a><\/p>\n\n\n\n
\n![\"billy04\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy04-800x600.jpg\")
<\/a><\/p>\n\n\n\n
\nThe flat part of the stainless steel D ring I cut off, leaving a little bit of the corner there, so it hold in place. With a lot manipulating, bending, etc, i got it in place.
\nNow the lid can be very easily removed or added with a stick.
\n![\"billy05\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy05-800x600.jpg\")
<\/a><\/p>\n\n\n\n
\n![\"billy06\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy06-800x600.jpg\")
<\/a><\/p>\n\n\n\n
\n![\"billy07\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy07-800x600.jpg\")
<\/a><\/p>\n\n\n\n
\n![\"billy08\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy08-800x600.jpg\")
<\/a><\/p>\n\n\n\n
![\"billy09\"](\"http:\/\/dabberty.com\/wp-content\/uploads\/billy09-800x600.jpg\")
<\/a><\/p>\n\n\n\n